EGO POWER + SNT2100 User Manual

56V LITHIUM-ION CORDLESS BRUSHLESS SNOW BLOWER — SNT2100 29
2. Remove the spring from the hook by
needle nose pliers (not included) to
release the belt tension (Fig. 30 & 31).
3. Remove the drive belt by
slowly turning the auger pulley
counterclockwise while pulling the
belt outwards (Fig. 32).
4. Install the new drive belt, rotating it
onto the pulleys (Fig. 33).
Tips: Rotate the new drive belt rst
around the engine pulley, then the idle
pulley, and nally around the auger pulley.
Slowly turn the auger pulley clockwise to
drive the belt inwards.
5. Install the spring onto the hook to
tension the drive belt (Fig. 30).
6. Install the drive belt cover with the
screws (Fig. 28).
NOTICE: Ensure that the drive belt is
properly adjusted and rotating without
incline.
32
31
33
30
Needle nose pliers

EGO POWER + SNT2100 Specifications

General

Brand	EGO
Model	POWER + SNT2100
Category	Snow Blower
Language	English