EasyManuals Logo

EGO POWER + SNT2100 User Manual

EGO POWER + SNT2100
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
56V LITHIUM-ION CORDLESS BRUSHLESS SNOW BLOWER — SNT210028
REPLACING THE RUBBER
PADDLE
WARNING:
Make sure to turn off
the bail switch, remove the battery packs
before performing any maintenance task
on your snow blower.
NOTICE: When replacing the worn
rubber paddles, pay close attention to
the order in which you remove them.
Assemble the new rubber paddles in the
reverse order of the disassembly.
1. By using two 10mm wrenches(not
included), remove the 8 sets of nuts
and bolts xed on the middle steel
plates and 8 sets of nuts, washers
and bolts on both sides, that are
used to secure the rubber paddles
(Fig. 26 & 27).
2. Install the new rubber paddles in the
reverse order of the disassembly.
Secure them by tightening the 8
sets of nuts, washers and bolts on
both sides and the 8 sets of nuts
and bolts in the middle.
REPLACING THE DRIVE BELT
If the drive belt becomes worn,
oil-soaked, excessively cracked, frayed,
or otherwise damaged, replace the belt.
WARNING:
Make sure to turn off
the bail switch, remove the battery packs
before performing any maintenance task
on your snow blower.
1. Remove the drive belt cover by removing the 8 screws as shown in Fig. 28.
26
4 sets of bolts, washers and
nuts separately on both sides
8 sets of bolts
and nuts
27
Steel Plates
28
Screw
Drive Belt
Cover
29
Auger Pulley
Idler Pulley
Spring
Engine
Pulley
Drive Belt
Hook

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EGO POWER + SNT2100 and is the answer not in the manual?

EGO POWER + SNT2100 Specifications

General IconGeneral
BrandEGO
ModelPOWER + SNT2100
CategorySnow Blower
LanguageEnglish

Related product manuals