PROBLEM CAUSE SOLUTION
The mower does
not mulch properly
◾ Wet grass clippings are sticking to the
underside of the deck.
◾ Wait until the grass dries before mowing.
◾ The mower is set to cut too much grass
at once.
◾ Raise the deck to a higher cutting height
setting.
There is excessive
vibration
◾ The cutting blade is loose. ◾ Tighten the blade bolt.
◾ The cutting blade is unbalanced. ◾ Balance the blade following the
instructions.
◾ The cutting blade is bent. ◾ Replace the blade.
◾ The motor shaft is bent. ◾ Contact the service center.
The handle locking
clamps cannot be
closed in position
◾ The side rails are not fully extended. ◾ Fully extend the side rails, then lock the
clamps.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
To Next Page
Loading...
