56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2110/LM2110-FC/LM2110SP/LM2110SP-FC/LM2120SP/LM2120SP-FC8
◾
Dress properly – Do not wear loose clothing or jewelry. They can be caught
in moving parts. Use of rubber gloves and footwear is recommended when
working outdoors. Wear sturdy, rough-soled work shoes and close-fitting pants
and shirts. Shirts and pants that cover the arms and legs and steel-toed shoes
are recommended. Never operate this machine in bare feet, sandals, slippery or
lightweight (e.g., canvas) shoes.
◾
Never pull the mower back toward you while you are walking. If you must back the
mower away from a wall or obstruction, first look down and behind you to avoid
tripping, and then follow these steps:
◾
Step back from mower to fully extend your arms.
◾
Be sure you are well balanced with sure footing.
◾
Pull the mower back slowly, no more than half way toward you.
◾
Repeat these steps as needed.
◾
The motor/blade control handle is a safety device. Never attempt to bypass its
operation. Doing so makes the safety device inoperative and may result in personal
injury through contact with the rotating blade. The motor/blade control handle must
operate easily in both directions and automatically return to the disengaged position
when released.
◾
Avoid dangerous environments – Don’t use lawn mowers in damp or wet locations
so as to avoid slipping and falling during operation.
◾
Always be sure of your footing. A slip and fall can cause serious personal injury.
If you feel you are losing your footing, release the motor/blade control handle
immediately and the blade will stop rotating within three seconds.
◾
Mow only in daylight or good artificial light. Walk, never run while operating.
◾
Stop the blade when crossing gravel drives, walks or roads.
◾
If the equipment should start to vibrate abnormally, immediately stop the motor,
remove the battery and check for the cause. Vibration is generally a warning of
trouble.
◾
Before cleaning the machine, unclogging the chute or removing or replacing the
grass bag, mulching insert, or side discharge chute, turn the motor off and wait
until the blade comes to a complete stop, then remove the battery pack. The
cutting blade continues to rotate for a few seconds after the motor is shut off.
Never place any part of the body in the blade area until you are sure the blade has
stopped rotating.
◾
Never operate the mower without the proper trailing shield, discharge door, grass
bag, mulching insert, side discharge chute, motor/blade control handle or other
To Next Page
Loading...
Need help?
General
