EGO SNT2400 User Manual

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC16
TO INSTALL THE SNOW-
DISCHARGE CHUTE ASSEMBLY
WARNING:
Never operate the
snow blower without the complete
discharge chute in place.
1. Loosen the knob on the inner
support pole and remove the bolt
(Fig.5). Save the knob and bolt for
reassembly.
2. Lift the snow-discharge chute
assembly, align the outer support
pole with the inner support pole,
and then slide the outer support
pole into place (Fig. 5). Make sure
that the snow-discharge chute is
correctly seated on the base (Fig.6).
3. Secure the snow discharge chute assembly with the reserved knob and bolt.
WARNING:
Use the chute rotation handle to make sure that the chute rotates
properly and that the discharge opening never crosses the operator controls.
6
Snow-discharge
Chute
Base
5
Outer Support Pole
Knob
Base
Bolt
Inner Support Pole
Snow-discharge
Chute

EGO SNT2400 Specifications

General

Stage Type	Two-stage
Clearing Width	24 inches
Battery Voltage	56 V
Auger Material	Steel
Drive System	Self-Propelled
Speed Control	Variable Speed
Intake Height	20 inches
Throwing Distance	50 feet
Number of Batteries	2
Chute Control	Remote
Speed Settings	Variable
Headlights	LED
Chute Rotation	200 degrees