To Next Page

To Previous Page

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC 17

OPERATION

WARNING:

Do not allow familiarity with this product to make you careless.

Remember that a careless fraction of a second is sufcient to inict serious injury.

WARNING:

Always wear eye protection with side shields marked to comply with

ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes and

other possible serious injuries.

WARNING:

Do not use any attachments or accessories not recommended by the

manufacturer of this product. The use of attachments or accessories not recommended

can result in serious personal injury.

APPLICATION

You may use this product for purpose listed below:

Removing snow from areas such as driveways and sidewalks.

HANDLE-HEIGHT ADJUSTMENT

The handle assembly can be set to three

different heights. Choose a comfortable

operating position according to your

height.

1. Loosen the two upper locking knobs

and pull out the two bolts (Fig.7).

Save them for reassembly.

2. Loosen the two lower locking knobs. It is not necessary to remove the two lower

locking knobs and bolts from the side rails during handle height adjustment.

3. Raise or lower the handle and select the appropriate height relative to the

positions of the holes in the rear handle.

4. Once arriving at the appropriate holes, tighten the handle with the reserved knobs

and bolts; then tighten the two lower locking knobs to secure the rear handle.

Upper

Locking Knob

Lower

Locking Knob

Other manuals for EGO SNT2400

Questions and Answers:

Need help?

Do you have a question about the EGO SNT2400 and is the answer not in the manual?

General