To Next Page

To Previous Page

SNOW SHOVEL ATTACHMENT — SSA1200/SSA1200-FC20

TRANSMISSION GEARS LUBRICATION

The transmission gears in the gear case need be lubricated periodically with gear

grease. Check the gear case grease level about every 50 hours of operation by

removing the sealing screw on the side of the case.

If no grease can be seen on the sides of the gear, follow the steps below to ﬁll with the

gear case with grease up to 3/4 capacity. Do not completely ﬁll the transmission gear

case.

1. Position the edger upright so that

the sealing screw is facing upwards

(Fig. 6).

2. Use the multi-function wrench

provided to loosen and remove the

sealing screw.

3. Use a grease syringe (not included)

to inject some grease into the screw

hole; do not exceed 3/4 capacity.

4. Tighten the sealing screw after

injection.

TRANSPORTING AND STORING

◾

Remove the battery pack from the tool.

◾

Clean the tool thoroughly before storing it.

◾

Store the tool in a dry, well-ventilated area, locked-up or up high, out of the reach

of children. Do not store the tool on or adjacent to fertilizers, gasoline, or other

chemicals.

Gear Case

Sealing Screw

EGO SSA1200 User Manual

Questions and Answers: