SNOW SHOVEL ATTACHMENT — SSA1200/SSA1200-FC 19
MAINTENANCE
WARNING: When servicing, use only EGO genuine replacement parts. Use of
any other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified service technician.
WARNING: To prevent serious personal injury, remove the battery pack from the power
head before inspecting, cleaning, performing maintenance or changing add-on attachments.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING: When cleaning the snow shovel attachment, DO NOT immerse it in
water or other liquids.
MOUNTING AND DETACHING THE
SCRAPER BAR
1. Remove the battery pack from the
power head.
2. Lay the snow shovel attachment
on its side or any other convenient
position for scraper bar service.
3. Remove the four screws that are
located on the scraper bar, as well
as the two screws at both ends. Use
a T20 screwdriver (not included) to
unscrew them (Fig. 5a & 5b).
4. Replace the worn scraper bar with a
new one.
5. To reassemble, first insert the new
scraper bar, with the six holes
aligned, insert the six screws into
the holes and secure them with a
screwdriver (not included).
5b
5a
Scraper Bar
To Next Page
Loading...
Need help?
General