56-VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1620/ST1620-FC 25
RELOAD THE CUTTING LINE
NOTICE: When the cutting line gets stuck in the trimmer head, you will need to remove
the remaining cutting line from the trimmer head and follow the steps below to reload
the line.
1. Remove the battery pack from the trimmer.
2. Press the release tabs on the trimmer head and remove the lower cover assembly
of the trimmer head by pulling it straight out (Fig. 24a & 24b).
3. Remove the cutting line from the trimmer head.
4. With one hand holding the trimmer, use another hand to grasp the lower cover
assembly and align the slots in the lower cover assembly with the release tabs.
Press the lower cover assembly until it snaps into place, at which time you will
hear a distinct click sound (Fig. 25).
5. Follow the instructions in the “LINE REPLACEMENT” section to reload the cutting
line.
24a
Lower Cover
Assembly
Release Tab
24b
②
①
25
Slot
Release Tab
To Next Page
Loading...
