56-VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1620/ST1620-FC32
PROBLEM CAUSE SOLUTION
The cutting
line cannot be
wound into the
trimmer head
properly.
◾
Improper cutting line is used.
◾
We suggest that you use EGO
original nylon cutting line see
“Recommended Cutting Line”
section in this manual. If using
EGO nylon line and the problem
persists, please call EGO customer
service for advice.
◾
Grass debris or dirt has
accumulated in the trimmer head
and blocked the movement of line
spool.
◾
Remove the battery, open the
trimmer head and clean it
thoroughly.
◾
Motor is overheated due to
repeatedly operating the line
winding system.
◾
Let the string trimmer work under
no load for a few minutes to cool
the motor, then try to reload the
line.
◾
Low battery capacity
◾
Charge the battery.
◾
The line is not wound into the
spool assembly.
◾
Pull out the line and reinsert it.
◾
Trimmer head malfunction.
◾
Call EGO Customer Service for
help.
The cutting
line cannot
be passed
through the
trimmer head
when inserting
the line.
◾
The cutting line is split or bent at
the end.
◾
Cut the worn end of line and
reinsert.
To Next Page
Loading...
Need help?
General
