28 © 2016 - 2017, Euro Games Technology Ltd.
HARDWARE
c) Blinking mode:
- blinks at 500 ms in phase with Hand Pay Lamp (red) and counter-phase
with Open Door Lamp (yellow);
- only in Calculator mode the lamp lights continuously and goes off at exit
from this mode.
III.7.1. Exciter II/ Exciter III Motherboard and Exciter II/ Exciter III Con-
nectors Board Box
Description: Blow the dust away from the fun and the processor radiator us-
ing a mighty air stream. Clean only when the power is switched off! For prevention
can address to the nearest EGT service.
Recommended Maintenance Period: monthly.
Cleaning: Clean the dust from the outside of the fan. Use a soft brush
and vacuum cleaner. Clean only when the power is switched off!
III.7.2. Monitors/ Touchscreen
Description: Upon normal operation a part of grease and contamina-
tions on players’ fingers remain on the touchscreen, which may impair its sensitivity
in some zones.
Recommended Maintenance Period: minimum once a week, recom-
mended after each client.
Cleaning: With a soft cloth and glass cleaning liquid. Do not allow leak-
ages of cleaning chemical and soaking of seals. In most cases this leads to interrup-
tion or full blocking of device operation.
III.7.3. Cabinet Fans
Description: Accumulation of dust on the fans impairs machine cooling
and may become and obstacle for its normal operation.
Recommended Maintenance Period: each 3 months.
Cleaning: Use a soft brush and vacuum cleaner. Clean only when the
power is switched off! If a fan stops working or works with a high noise level, it
should be replaced by a new one with the same model.
III.7.4. Bill Validator
Description: Upon normal operation dirt from bills is transferred into
the device and accumulated on pressing rolls, magnetic head and optical sensors of
the unit.
III.7. COMPONENT MAINTENANCE
GAMING MACHINE SERVICE
To Next Page
Loading...