4. Installation
4.1 Installation Procedure
1. Select a location complying with the advice
in Section 3.
2. Remove the mounting plate from the
packaging/Alarm.
3. Place the mounting plate on the ceiling/wall
exactly where you want to mount the Alarm.
With a pencil, mark the location of the two
screw holes.
4. Taking care to avoid any electrical wiring in
the ceiling, drill holes using a 5.0mm drill bit
through the centre of the marked locations.
Push the plastic screw anchors provided into
the drilled holes. Screw the mounting plate to
the ceiling/wall.
5. Alternatively, if desired, the CO Alarm will also free stand on a flat surface
with the mounting plate attached.
6. If using the RadioLINK interconnection, ensure the RF module is fitted
correctly into the base of the Alarm. For further advice on the RadioLINK
installation, see booklet Ò RadioLINK Module for Battery Powered Carbon
Monoxide AlarmsÓ .
7. Carefully line up the Alarm on the base, gentle press home & twist on Ð
see figure 4. (This connects the batteries). The red, amber & green lights will
15
Figure 4
Installation
To Next Page
Loading...
