27
Please note in a hybrid system containing CO / Heat / Fire / Smoke Alarms we recommend using an
Ei3000 series Alarm as the hybrid link to the RF section of the system.
Ensure the Alarms operate correctly - see TESTING YOUR ALARM in the user section.
2.8 Removing the Alarm
* Disconnect mains before removal *
Locate removal slot Insert screwdriver
Slide Alarm off base
Remove Alarm
Locate the arrow on the front face of the Alarm
The slot is located directly above the arrow
With the screwdriver still inserted, push the lower
half of the Alarm away from the screwdriver, it the
direction of the arrows on the cover
Hold the lower half of the Alarm and remove from
the baseplate by lowering the Alarm towards
the floor
Insert a flat-bladed screwdriver horizontally
about 10mm into the centre of the removal slot
To Next Page
Loading...