What to do if the Ethernet Link LED is not on for ei3 Amphion S14-N?
If the Ethernet Link LED is not lit, the cause may be incorrect network wiring or a bad port. You should check the cables and switches. It could also be due to improper configuration of the IP address settings on the Amphion. If this is the case, correct the settings or use the IP Config test and contact your ei3 administrator.
Why is the Blue Tunnel LED not on for my ei3 Amphion S14-N Network Hardware?
The Blue Tunnel LED might not be on due to several reasons. It could be that the local network cables, switches, or facility firewall rules are not correct. Check the cables and switches in the LAN, and consult with your local IT department regarding the firewall settings. Also, the IP information configured in S14 might be incorrect. Carefully check the IP configuration or reconfigure the device using the USB drive method with a newly generated configuration file. Another possible cause is that traffic is being blocked on SFLAN or a local facility Firewall. Reboot the device and perform a Ping test, then contact local IT. Finally, the LAN might not permit internet access. Perform the IP Config test.
How to fix ei3 Amphion S14-N Network Hardware when the Green System LED is not on?
If the Green System LED is not on, it indicates that the Amphion is not running. Try rebooting the device by cycling the power.
What to do if the Ethernet Link network activity LED is not flashing on my ei3 Network Hardware?
If the Ethernet Link network activity LED is not flashing, it could be due to a lack of Ethernet network activity or a wiring problem. Check the cables and switches, and verify if traffic should be occurring on the connected devices.
How to troubleshoot ei3 Amphion S14-N Network Hardware with Yellow Power LED not on?
If the Yellow Power LED is not on, this indicates that there is no power or incorrect power to the 24VDC terminals. Check for the correct 24VDC power supply and wiring.
Details the S14-H (RSSD, green box), S14-N (MRFD, red box), and S14-C (black box) models and their primary functions.
Covers 24VDC power requirements and proper grounding procedures for the Amphion S14.
Details the "To ei³" and "To Machine" Ethernet ports, including Machine LAN, Internet connectivity, and USB configuration port.
Lists hardware details, optional wall plug power supply, and microSD card functionality.
Details the 'Name', 'Wire Type', 'Connector', 'To', and 'Function' for various device terminations.
Provides guidelines for wiring, placement, initial boot process, and LED indicators.
Describes the unique 6-digit alphanumeric serial number and the ei³ Project number format for identifying Amphions.
Details using a configuration file (.ei3) created by an administrator and transferred via a USB drive for setup.
Explains using the Web Interface with administrator credentials for network information input for S14-N.
Explains rebooting the Amphion S14 after configuration and final installation steps.
Explains the meaning of Yellow, Green, and Blue LEDs and Ethernet Link Lights for device status.
Details troubleshooting steps based on LED status, probable causes, and network issues.
Outlines a procedure to perform an IP Config test for troubleshooting Amphion installation and network connectivity.
Details warranty coverage and the process for obtaining a Return Material Authorization (RMA) for repairs.
General| Brand | ei3 |
|---|---|
| Model | Amphion S14-N |
| Category | Network Hardware |
| Language | English |
To Next Page
