5
USER MANUAL RETEVET™ PORTABLE ERG
T +49 7461 96 580 0 | F +49 7461 96 580 90 | export@eickemeyer.com | www.eickemeyer.com
2. GETTING STARTED
Connect the Cord to the Docking Station and Plug-in
• Attach the power brick plate that matches your electrical outlet to the power brick.
• Connect the power cord to the docking station.
• Connect the power brick to an electrical outlet. The power supply accepts 100 – 240 VAC, 50 / 60 Hz.
Let the Device Charge
The RETevet™ device charges its battery when in the docking station from either the USB or power brick connection. If the
power brick is connected, charging will be signifi cantly faster than if only a USB connection is present. The charging status is
shown on the display. If the display is blank, press the power button to turn it on. The RETevet™ device is shipped with a
partial charge.
Connect the Electrodes
Connect the 3-plug electrode lead to the blue lead connector shown in the fi gure above, and then connect the electrodes in
the following way: corneal electrode to the red plug, reference electrode to the black plug and the ground electrode to the
green plug.
Device Controls
The RETevet™ device has an up / down / right / left / select joystick and an on-off power button.
Turning the Device Off
You can turn the device off at any time by pressing the power button.
The screen goes blank immediately, but the device takes a few more seconds to turn off completely.
Wait a few seconds after the power indicator light stops blinking before turning the device back on.
To Next Page
Loading...
Need help?
General