13. Troubleshooting
Fault Possible causes Remedies
The motor fails to start a) The capacitor is defective a) The mower housing is
clogged Have repaired by
the Customer Service
Center
b) There is no electricity at the plug b) Check the cable and the
fuse
c) The cable is defective c) Check the cable
d) The combined switch/plug is d) Have repaired by the
defective Customer Service Center
e) The connectors have become e) Have repaired by the
separated from the motor Customer Service Center
or the capacitor
f) The mower is standing in high f) Start in low grass or on an
grass area that has already
been mowed; change the
cutting height if necessary
g) The mower housing is clogged g) Clean the housing so that
the blade moves freely
The motor performance drops a) The grass is too high or too damp a) Correct the cutting height
b) The mower housing is clogged b) Clean the housing
c) The blade is severely worn c) Replace the blade
Cutting is irregular a) The blade is worn a) Replace or resharpen the
blade
b) Wrong cutting height b) Correct the cutting height
Important!
For protection, the motor is equipped with a thermal switch which cuts out when the motor is overloaded and
switches on again automatically after a short cooling period.
19
GB
12.Technical data
Voltage: 230 V ~ 50 Hz
Power input: 1500 watts
Motor speed: 3400 rpm
Cutting width: 38 cm
Cutting height adjustment: 25-75 mm; 6 levels
Volume of catch bag: 48 liters
LPA sound pressure level: 81 dB(A)
LWA sound power level: 96 dB(A)
Vibration at the handlebars: ≤ 2.5 m/s
2
To Next Page
Loading...
