EINHELL GC-KS 2540 CB - 10. Troubleshooting guide

GB
- 13 -
10. Troubleshooting guide
Fault Possible cause Remedy
The machine does
not work
- No power at the plug
- Machine is switched off
- Overload switch has tripped
- Ejector chute is blocked
- Loading funnel is not secure on the
motor housing
- The safety switch is not making
contact
- Check the power cable and fuse
- Switch on machine
- Press control on overload switch
- Clean ejector chute
- Clean interior and tighten safety
screw
- Insert the debris box correctly and
push the safety switch upwards un-
til it engages
Shredding perfor-
mance unsatisfac-
tory
- Blades worn - Turn, sharpen or replace blades
Anl_GC_KS_2540_CB_GB_Korea.indb 13Anl_GC_KS_2540_CB_GB_Korea.indb 13 02.12.2022 11:12:1502.12.2022 11:12:15