EINHELL GC-KS 2540 Operating Instructions

GB
- 19 -
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Troubleshooting guide
Fault Possible cause Remedy
The machine does
not work
- No power at the plug
- Machine is switched off
- Overload switch has tripped
- Ejector chute is blocked
- Loading funnel is not secure on the
motor housing
- Check the power cable and fuse
- Switch on machine
- Press control on overload switch
- Clean ejector chute
- Clean interior and tighten safety
screw
Shredding perfor-
mance unsatisfac-
tory
- Blades worn - Turn, sharpen or replace blades
For EU countries only
Never place any electric power tools in your household refuse.
To comply with European Directive 2012/19/EC concerning old electric and electronic equipment and
its implementation in national laws, old electric power tools have to be separated from other waste and
disposed of in an environment-friendly fashion, e.g. by taking to a recycling depot.
Recycling alternative to the return request:
As an alternative to returning the equipment to the manufacturer, the owner of the electrical equipment
must make sure that the equipment is properly disposed of if he no longer wants to keep the equipment.
The old equipment can be returned to a suitable collection point that will dispose of the equipment in
accordance with the national recycling and waste disposal regulations. This does not apply to any ac-
cessories or aids without electrical components supplied with the old equipment.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_GC_KS_2540_SPK9.indb 19 20.12.2018 09:19:49

EINHELL GC-KS 2540 Specifications

General

Power	2000 W
Noise level	106 dB
Product color	Black, Red
Cutting system	Blade
AC input voltage	220-240 V
Rated speed (max)	3800 RPM
AC input frequency	50 Hz
Material throughput	- kg/h
Collection box capacity	- L
Maximum branch thickness	40 mm
Package depth	420 mm
Package width	300 mm
Package height	620 mm
Package weight	11600 g

Weight and Dimensions

Depth	625 mm
Width	290 mm
Height	423 mm
Weight	9900 g