To Next PageTo Next PageWhy EINHELL GC-PM 46/2 S HW Lawn Mower engine does not start?
If your EINHELL Lawn Mower engine doesn't start, try these steps: * Ensure the engine start/stop lever is pressed. * Check the throttle lever position (if your model has one). * Replace the spark plug if it's defective. * Refuel if the fuel tank is empty. * Actuate the fuel pump (primer) if your model has one.
What to do if EINHELL GC-PM 46/2 S HW leaves lawn yellow, uneven cut?
If your EINHELL Lawn Mower isn't cutting evenly and the lawn turns yellow, it could be due to a few reasons. The blade might not be sharp enough, so try sharpening it. Also, the cutting height might be too low; adjust it to a more appropriate level. Lastly, ensure the engine speed isn't too low by setting the throttle lever to max (if your lawnmower has one).
Why EINHELL GC-PM 46/2 S HW engine does not run smoothly?
If the engine of your EINHELL Lawn Mower isn't running smoothly, the air filter might be dirty, so try cleaning it. Another potential cause is a dirty spark plug, which should also be cleaned.
What to do if EINHELL Lawn Mower grass chute is not clean?
If the grass chute of your EINHELL Lawn Mower isn't clean, it could be because the engine speed is too low. Try setting the throttle lever to maximum. It might also be that the cutting height is too small, so set it properly. A worn blade can also cause this issue, so replace the blade if necessary. Finally, check if the grass bag is clogged and empty it if it is.
How to fix EINHELL Lawn Mower that vibrates intensively?
If your EINHELL Lawn Mower doesn't operate smoothly and vibrates intensively, check if any bolts are loose and tighten them. Also, make sure the blade attachment is secure. If the blade is imbalanced, consider replacing it.
General| Brand | EINHELL |
|---|---|
| Model | GC-PM 46/2 S HW |
| Category | Lawn Mower |
| Language | English |
Covers essential precautions like reading manuals, keeping them safe, and avoiding hazards.
Instructions for starting the petrol engine, including primer and start lever usage.
Verifying the proper function of the engine start/stop and drive levers.
Detailed steps for starting the engine and engaging the drive for mower movement.
Covers checking oil levels, changing engine oil, and blade maintenance/replacement.
Steps for preparing the mower for extended periods of non-use.
Instructions for safely preparing the lawn mower for transportation.
Addresses issues like excessive vibration and general operational smoothness.
Covers common issues like the engine not starting or running rough.
