12
GB
Fault Possible cause Remedy
Equipment does not work Power plug is not connected
Topple cut-out switch not pressed
Connect the power plug
Place the machine on a level
surface.
The equipment does not heat The thermostat control is set too
low
Overheating guard has been
triggered
The switch is set to blowing without
heating function.
Turn the thermostat control to the
right, to a higher temperature
Please note section 7.5
Set the heating function
11. Troubleshooting
If the equipment is operated properly you should experience no problems with malfunctions or faults. In the
event of any malfunctions or faults, please check the following before you contact your customer services.
To Next Page
Loading...
