To Next PageTo Next Page
Need help?Do you have a question about the EINHELL RT-AG 115 and is the answer not in the manual?
General| Power | 720 W |
|---|---|
| Disc Diameter | 115 mm |
| No-load Speed | 11000 RPM |
| Power Supply | 230 V |
| Spindle Thread | M14 |
Read and keep all safety regulations and instructions to prevent electric shock, fire, or serious injury.
Designed for grinding metal/stone. Cutting requires a guard. Not for commercial use.
Identifies hazards like lung, hearing, and hand-arm vibration damage if precautions are not taken.
Adjust guard for hand protection, ensure it locks correctly, and covers the gear wheel casing.
Safe procedure for replacing grinding or cutting wheels using the face spanner and spindle lock.
Use correct wheels, check speed ratings, ensure they exceed idle speed, and handle carefully.
Achieve best results by holding wheel at 30-40° angle to surface, moving steadily.
Cut without tilting, use clean edge wheels; diamond wheels suit hard stone.
Do not use on asbestos materials. Never use a cutting wheel for rough grinding.
Damaged cables must be replaced by authorized personnel to prevent electrical hazards.
Keep equipment clean by wiping or blowing. Use a moist cloth and mild soap for regular cleaning.
