EINHELL RT-HP 1750 TR User Manual (English)

Other manuals for EINHELL RT-HP 1750 TR

Questions and Answers:

B
Benjamin FlynnAug 12, 2025
Why is my EINHELL RT-HP 1750 TR Pressure Washer not building pressure?
- M
  mason06Aug 12, 2025
  If your EINHELL Pressure Washer motor starts but isn't building pressure, it could be due to a few reasons. The water intake filter might be clogged, so you should clean it. There could be air intake in the water inlet, so check the supply hose and hose connection, replacing them if necessary. Also, the discharge nozzle might be too large, requiring a check and possible replacement.
C
christopherrodriguezAug 18, 2025
What to do if my EINHELL RT-HP 1750 TR does not work?
- S
  solomonchelseaAug 19, 2025
  If your EINHELL Pressure Washer isn't working, here are a few things to check: - Ensure there is electrical voltage at the device. Check the fuse, power cable, and plug, replacing them if needed by qualified personnel. - Verify the extension cable's cross-section is adequate and not excessively long. Use shorter or larger cross-section cables. - Confirm that the mains voltage meets the specified requirements. Contact your power supply company if necessary. - Inspect the pump for freezing and thaw it if necessary.
L
Lauren SmithAug 27, 2025
Why is my EINHELL RT-HP 1750 TR Pressure Washer motor starting but not building pressure?
- B
  Bryan ClarkAug 27, 2025
  If the motor of your EINHELL Pressure Washer starts but pressure isn't building, consider these potential causes: - The water intake filter might be clogged. Clean the water intake filter. - There could be air intake in the water inlet. Check the supply hose and its connection, replacing if necessary. - The discharge nozzle might be too large. Check and replace if necessary.
R
rebecca15Sep 3, 2025
How to fix irregular operating pressure in my EINHELL RT-HP 1750 TR?
- J
  Jenny ShepherdSep 3, 2025
  If your EINHELL Pressure Washer has irregular operating pressure, it may be due to air intake in the water inlet. Check the supply hose and hose connection and replace if necessary.