GB
- 17 -
Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
2. Layout and items supplied
2.1 Layout (Fig. 3)
1 On/Off switch
2 Speed controller
3 Clamp nut
4 Locking knob for collet chuck
5 Cover
2.2 Items supplied (Fig. 1-2)
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Grinding and engraving tool
•
Case (1)
•
Grinding wheels (2)
•
Grinding belts (3)
•
Clamping spindles (4)
•
Cutters (5)
•
Felt polishers (10) / arbors (6)
•
Drill bits (7)
•
Locking pin (8)
•
Grinding pins (9)
•
Sleeves (11)
•
Cutting-off wheels (12)
•
Flexible shaft (13)
•
Table clamp (14)
•
Telescopic stand rod (15)
•
Grinding heads (16)
•
Pot brushes (17)
•
Abrasive paper (18)
•
Original operating instructions
•
Safety information
3. Proper use
The Grinding and Engraving Set is designed to
perform drilling, grinding, deburring, polishing,
engraving, cutting, milling and cleaning jobs
on wood, metal and plastic in model-making,
workshop and household applications. Use the
tool and accessories only for those applications
described.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Anl_TC_MG_135_E_SPK9.indb 17Anl_TC_MG_135_E_SPK9.indb 17 07.11.2019 09:22:5207.11.2019 09:22:52
To Next Page
Loading...
