EINHELL TC-SP 204 Operating Instructions

GB
- 26 -
For EU countries only
Never place any electric power tools in your household refuse.
To comply with European Directive 2012/19/EC concerning old electric and electronic equipment and
its implementation in national laws, old electric power tools have to be separated from other waste and
disposed of in an environment-friendly fashion, e.g. by taking to a recycling depot.
Recycling alternative to the return request:
As an alternative to returning the equipment to the manufacturer, the owner of the electrical equipment
must make sure that the equipment is properly disposed of if he no longer wants to keep the equipment.
The old equipment can be returned to a suitable collection point that will dispose of the equipment in
accordance with the national recycling and waste disposal regulations. This does not apply to any ac-
cessories or aids without electrical components supplied with the old equipment.
Please note that batteries and lamps (e.g. light bulbs) must be removed from the tool before it is dispo-
sed of.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers ac-
companying products is permitted only with the express consent of the Einhell Germany AG.
Subject to technical changes
•
The product meets the requirements of EN 61000-3-11 and is subject to special connection condi-
tions. This means that use of the product at any freely selectable connection point is not allowed.
•
Given unfavorable conditions in the power supply the product can cause the voltage to fluctuate
temporarily.
•
The product is intended solely for use at connection points that
a) do not exceed a maximum permitted supply impedance, or
b) have a continuous current-carrying capacity of the mains of at least 100 A per phase.
•
As the user, you are required to ensure, in consultation with your electric power company if neces-
sary, that the connection point at which you wish to operate the product meets one of the two requi-
rements, a) or b), named above.
Anl_TC_SP_204_SPK9.indb 26 19.06.2023 08:46:43

EINHELL TC-SP 204 Specifications

General

Power	1500 W
Feed rate	6 m/min
Idle speed	9000 RPM
Dust extraction	Yes
AC input voltage	230-240 V
AC input frequency	50 Hz
Planning width (max)	204 mm
Dust adapter diameter	100 mm
Thickness opening (max)	120 mm
Parallel guide tilt angle (max)	45 °
Surface planing material removal (max)	3 mm
Thickness planing material removal (max)	2 mm

Weight and Dimensions

Weight	27200 g
Package depth	850 mm
Package width	425 mm
Package height	465 mm
Package weight	31150 g
Feed table dimensions (W x D)	370 x 210 mm
Thicknessing table dimensions (W x D)	270 x 210 mm