Operation
4.4. Enrolment of a finger
4.4.1. How to swipe a finger correctly over the sensor
In order for the reader to properly scan and recognize a particular finger, the finger needs to be
positioned and swiped correctly over the sensor as outlined below:
a. Locate the reader sensor between the 2 green illuminated arrows.
b. Starting from the finger joint, place the finger flat over the sensor. It is very important that the
whole finger is placed flat over the senor and not just the tip.
- 10 -
c. Apply little pressure and start swiping the finger immediately all the way down. The bigger the
identified finger surface, the higher is the probability that you are recognised again by the system.
Senso
To Next Page
Loading...
