Only use the recommended/supplied batteries or equivalent.
Rechargeable batteries are to be removed from the unit before being charged.
The supply terminals are not to be short-circuited.
Use alkaline batteries for longer life.
Do not mix old and new batteries, and do not mix alkaline, carbon-zinc or rechargeable nickel-cadmium
batteries.
Insert batteries with proper polarity (+/–) as indicated.
Remove exhausted batteries from product.
Recharge rechargeable batteries under adult supervision.
Do not attempt to recharge non-rechargeable batteries.
Do not open batteries or heat them beyond normal ambient temperatures.
To prevent battery leakage or damage remove batteries from a product if it will not be used for a month or
longer.
Use extreme caution handling leaking batteries (avoid direct contact with eyes and skin). If battery leakage
comes in contact with eyes, IMMEDIATELY flush the eye with lukewarm and gently flowing water for at least 30
minutes. If skin contact occurs, wash skin with clear water for at least 15 minutes. Seek medical attention if any
symptoms occur.
Store in cool, dry, ventilated area away from hazardous or combustible material.
Do not dispose of batteries in the household trash or fire.
Follow applicable laws and local regulations for the disposal and transportation of batteries.
Do not dispose of batteries in fire; batteries may leak or explode.
Batteries should be replaced by an adult.
Remove all packaging before giving to your child.
BASIC FUNCTION
SWITCHING ON THE UNIT
After connecting the power, press the SOURCE button to turn the unit ON or OFF. NOTE: In CD/AUX mode, when
the unit is not providing the main function for 15 minutes, the unit will automatically switch into standby mode. Press
the SOURCE button to turn on the unit again.
Please note that low volume setting in the audio source may be recognized as “no audio signal”, this will affect the
capability of signal detection from the device and can also originate an automatic switch into standby mode. If this
happens please reactivate the audio signal transmission or increase the volume setting on the audio source player in
order to resume playback.
Electrostatic Discharge hints – The unit may reset or may not reset to normal operation mode due to electrostatic
discharge, just switch it off and reconnect again.
ADJUSTING VOLUME
Press the VOLUME-/VOLUME+ button on unit to increase or decrease volume.
RADIO OPERATION
TUNING RADIO STATIONS
1. Press the SOURCE button on unit to select the FM mode.
2. Tune to desired station by pressing the or on unit, the display will show the band frequency. Example: FM 97.10
MHz.
3. Extend FM TELESCOPIC ANTENNA to its full length and gently move the unit back and forth to get the best
reception, or place the unit in an open location.
4. To turn off the radio, press the SOURCE button to select other functions, or turn off the unit.
RADIO AUTO SCAN (SEARCH)
Press and hold the REPEAT/SCAN/M.+ button on unit, the unit will conduct an auto scan until a strong signal is
found. The unit will start to broadcast from the P01 after searching is complete.
RADIO MANUAL PRESET MEMORY OPERATION
You may pre-store 30 (FM) radio stations in memory for your preference.
1. Press the or to select the first desired station, then press MEM./PROG button on unit, “PROGRAM” indicator will
flash on the display.
2. Use REPEAT/SCAN/M.+ buttons to choose the desired sequence you want to store, then press the
To Next Page
Loading...
