SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
Press the or button on unit while in stop mode, or during playback, until the desired track appears on the display. It
will start to play automatically.
To search for a particular passage during playback (track scanning at high speed) Press and hold the or button on
unit to scan the current playing track at high speed until desired point (passage) appears, then release the button for
normal playback mode. Playback will start again from this point.
PROGRAMMING TRACKS
Programming tracks is possible when playback is stopped. Up to 20 tracks of a CD can be stored in the memory in
any order.
1. In stop mode, press and hold the MEM./PROG button. The unit enters program setting, the “PROGRAM”
indicator will flash on the display and show P01.
2. Press the or button to select the first desired track to be programmed. (example: track 2)
3. Press and hold the MEM./PROG button on unit to enter. The display would flash PROGRAM and show P02.
4. Repeat steps 2 & 3 to store other desired tracks until all tracks programmed.
5. Press the REPEAT/SCAN/M.+ button on unit to start playback from the first programmed track.
6. Press the MEM./PROG button on unit to stop program playback. To clear the program, you may press
MEM./PROG button on unit when the disc stopped and open the CD compartment lid, the program will be
erased.
REPEAT PLAY
You can play one track or all tracks on the disc repeatedly.
To Repeat a Single Track
1. Press and hold REPEAT/SCAN/M.+ button on unit during play, the display will show a flash “REPEAT” indicator
and the current track will be played over and over again until you press the MEM./PROG button on unit .
2. To cancel repeat play, press REPEAT/SCAN/M.+ button on unit until “REPEAT” disappears from the display.
To repeat all the Tracks
1. Press and hold REPEAT/SCAN/M.+ button on unit until the “REPEAT” indicator shows steadily on the display,
all tracks on the disc will be played over and over again till you press the MEM./PROG button on unit.
2. To cancel repeat play, press REPEAT/SCAN/M.+ button on unit until “REPEAT” disappears from the display.
RANDOM PLAY
Press and hold the REPEAT/SCAN/M.+ button on unit till the “RAN” shows steadily on the display, the random play
will start from next track automatically, until all tracks are played over and then it will stop. Press the
REPEAT/SCAN/M.+ button on unit again until the “RAN” disappears from the display to cancel.
AUX-IN OPERATION
1. Press the SOURCE button to select “AUX” mode.
2. Insert one end of a AUX line plug into the AUX IN jack (3.5mm) on the unit, and the other end to the headphone
jack of your music device to amplify music.
3. Adjust the volume on the unit or on the device to your desired level.
4. Control play/pause and navigate tracks using your music device.
File Downloads
To Next Page
Loading...
