EKKO EB12E Series - 7.1. Maintain inventory

- 14 -
- 14 -
- 14 -
7.1. Maintain inventory
Table4: Maintain inventory
The interval of time
(month)
1
2
6
12
1
Check the hydraulic oil cylinder, the piston is there noise and
leakage damage
●
2
Check the hydraulic connections and tubing for damage and
leakage
●
3
Check the hydraulic oil level, then fill if necessary
●
4
And then filled with hydraulic oil (12 months or 1500 hours)
●
5
Check and adjust the pressure valve function (2205ib+0/
+10%)
●
Mechanical system
6
Check whether the deformation and crack of fork
●
7
Check whether the deformation and crack of the chassis
●
8
Check all the screws are fixed completely
●
9
Check the door frame and the chain if there is corrosion,
deformation or damage, replace if necessary
●
10
Check whether the noise and leakage of gear box
●
11
Check whether the wheel deformation and damage, replace if
necessary
●
12
A steering bearing lubrication
●
13
Check and lubrication center point
●
14
Grease nozzle
●
15
Protective and / or protection board, if damaged, replace
●
15
The electrical system
16
Check the wire is damaged
16
Check the wire is damaged
●
17
Check the electrical connectors and connecting terminal
●
18
Detection of the emergency stop switch function
●
19
Check whether the electric drive motor noise and damage
●
20
Detection display
●
21
Check whether the use of the correct fuse, replace if necessary
●
22
Test buzzer
●
23
Check the current contactor
●
24
Check whether there is leakage of the frame (insulation test)
●
25
Check the accelerator function and wear
●
26
Check the drive motor of electric system
●
Brake system
27
Check the brake performance, brake disc replacement or
adjustment gap if necessary
●
Battery
28
Check the battery voltage
●
29
Clean and give the terminal grease, check whether there is
corrosion and damage
●
30
Check the battery shell is damaged
●
Charger
31
Check the main power line is damaged
●
32
Start protection program check during charging
●
Function