EKOM DK50-10 Series - User Manual

Questions and Answers

M
Marissa RamirezAug 4, 2025
How to troubleshoot an EKOM DK50-10 that won't start?
- E
  Elizabeth RyanAug 4, 2025
  If your EKOM Air Compressor does not start, there might be several reasons. First, check the voltage in the socket, as there might be no voltage at the pressure switch. Other potential causes include motor winding failure or damaged thermal overload protection, requiring motor or windings replacement; a faulty capacitor that needs replacement; a seized piston or other rotating part, necessitating replacement of the damaged parts; or a pressure switch malfunction, which requires checking its function.
S
Sarah HallAug 9, 2025
Why is my EKOM Air Compressor running for a long time?
- J
  Jeffrey WallsAug 9, 2025
  If your EKOM Air Compressor is running for a prolonged time, it could be due to several reasons. Check for air leaks in the compressed air distribution system and seal any loose joints. A worn piston ring can also cause this issue, requiring replacement. Additionally, inspect the inlet filter for blockage and replace it if necessary. A defective solenoid valve can also be the cause, so consider repairing or replacing the valve or coil.
S
Sarah VargasAug 15, 2025
Why does my EKOM DK50-10 Air Compressor turn on and off frequently?
- M
  Michael StewartAug 15, 2025
  If your EKOM Air Compressor switches on frequently, it could be due to several reasons. There might be an air leak in the compressed air distribution system; check and seal any loose joints. A leaking check valve could also be the cause; try to clean the solenoid valve, replace the seals, or replace the entire solenoid valve. A large volume of condensed liquid in the pressure vessel could be another reason, so drain the condensed liquid. Finally, low compressor performance could be the issue; check the time it takes to fill the air tank.
K
Kyle CortezAug 21, 2025
What to do if my EKOM DK50-10 Air Compressor is making loud noises?
- K
  kwilkersonAug 21, 2025
  If your EKOM Air Compressor is excessively noisy with knocking or metal sounds, it may be due to a damaged piston bearing, piston rod, or motor bearing, which would require replacing the damaged bearing. Another possible cause is a loose or cracked spring, which would also need replacement.
J
Jason WilliamsAug 27, 2025
What causes the dryer in my EKOM DK50-10 to not dry properly?
- E
  Ethan McgeeAug 27, 2025
  If the dryer in your EKOM Air Compressor isn't drying and there's condensed water in the air, it could be due to a few reasons. The cooling fan may not be working, necessitating its replacement. The dryer itself might be damaged and need replacing. Alternatively, the automatic condensate drain might be non-functioning; try cleaning or replacing it on the filter.