Configuration Mode
If this is the the device turns on or if a has been performed, it will not have stored any WLAN configuration. So new first time factory reset
connection settings are required.
Connecting with a device in configuration mode is helpful for those situations where you want to collect some information, like the device’s serial
number, before configuring the WIFI.
Streaming Mode
When the WLAN has been configured successfully in the device, and the eKP4T is connected to the WLAN and ready to be managed and sent
the data to the host system.
Heartbeat Monitor
Verification process to ensure that data is being transferred between the device and the software. Regular “calls” (every 1-3s) are launched from
the software to the device.
Features of eKuore Pro For Telemedicine SDK iOS
eKuore Pro For Telemedicine iOS SDK provides management functionalities for an device:eKP4T
Configure the connection (IP, SSID, password, and ports) of the eKP4T device with a router in a WLAN.
Manage the device connection.
Manage the streaming of auscultation audio from an eKP4T device in real-time through a WLAN.
Check the device information when the device is connected to the same WLAN where the system runs.
Get Battery Level.
Interacting with device characteristics: Filter, Volume and LedStatus.
Get device characteristics in real-time. We use the swift Combine framework to publish any changes to the device.
Change device characteristics.
Listen to connection status changes
.connected
.hardwareDisconnected
.disconnecting
.disconnected
.waiting(let error)
.failed(let error)
Utilities
Device discovering (beta) allow discovering all device in the network.eKP4T
To Next Page
Loading...
