- 12 - - 13 -
ATTACHING THE FITTINGS
OUTLET
INLET
EK recommends using EK-Quantum Torque Fittings
with the EK-Quantum Inertia D5 PWM D-RGB series
pump tops. To ensure the tubes are securely attached
to the barb/fitting, please use hose clamps or an
appropriate substitute.
• It is mandatory to use the correct INLET and
OUTLET ports.
• The OUTLET is the G1/4 threaded opening on the
side of the pump-top housing.
• The INLET (suction) port is the central G1/4
threaded opening on the EK-Quantum Inertia D5
PWM D-RGB front face plane.
• Make sure not to use fittings or barbs with a
G1/4 thread longer than 5mm! All EK fittings are
compatible.
To Next Page
Loading...
