- 5 -
On the Multiport Radiator, opposing to the inlet/outlet side of the radiator,
there is an extra port for filling or draining the loop.
It should not be used as an inlet or an outlet port!
EK recommends using the same number of inlets and
outlets for the most optimal performance!
It is mandatory to use the extenders on any inlet and
outlet position!
If transferred from the stock position of the radiator
to another, check if the extenders are tightened to
avoid leakage!
The same port setup applies for all EK-Quantum Surface
radiator variants!
FILL/DRAIN
PORT
To Next Page
Loading...
