Need help?Do you have a question about the ELAC Alchemy PPA-2 and is the answer not in the manual?
Avoid overload, do not open the unit. Clean with soft cloth. Listen responsibly to volume.
Explains front panel buttons (POWER, MUTE, INPUT 1/2, HP, MC/MM, MONO) and indicators.
Check input, gain, loading, and mute status.
Verify load settings. Address hum by checking grounding, wire position, or system components.
Avoid overload, do not open the unit. Clean with soft cloth. Listen responsibly to volume.
Explains front panel buttons (POWER, MUTE, INPUT 1/2, HP, MC/MM, MONO) and indicators.
Check input, gain, loading, and mute status.
Verify load settings. Address hum by checking grounding, wire position, or system components.
General| Type | Phono Preamplifier |
|---|---|
| Gain MM | 40dB |
| RIAA accuracy | ±0.2dB |
| Signal-to-Noise Ratio (MM) | 90dB |
| Output Impedance | 100 ohms |
| Total Harmonic Distortion | <0.001% |
| Input Impedance | 47k ohms (MM), 47-1k ohms (MC) |
| Signal-to-Noise Ratio | 90dB (MM), 75dB (MC) |
| Input Capacitance | 47pF |
| Gain MC | 60dB |
| THD+N | <0.001% |
| Inputs | 2x RCA |
| Outputs | 1 x RCA |
| THD | <0.001% |
| Signal-to-Noise Ratio (MC) | 75dB |
| Power Supply | External 15V DC |
| Frequency Response | 20Hz - 20kHz |
To Next Page
