ABOUT THE M SERIES
MOUNTING CLAMP DESIGN
All models in the ELAN M Series speaker
line feature rigid, heavy-duty mounting
clamps that ensure a quick, secure,
vibration-free installation in walls from
1/2" to 1-1/2" in thickness.
The ceiling models and 5.25" In-Walls
have four mounting clamps each. The 6.5"
and 8" In-Wall models have six mounting
clamps.
DAMPING THE WALL CAVITY
Damping the wall/ceiling cavity behind the
speakers by loosely filling it with fire-rated
fiberglass insulation can enhance the per-
formance of your M Series speakers and
reduce unwanted transmission of sound
into adjacent rooms.
PAINTING THE SPEAKERS
All ELAN M SERIES speakers can be
finished to match any room décor. Their
white, textured frames and no-rust
aluminum grilles readily accept most
water-based interior latex and spray enamels.
We recommend the grille and frame be
painted separately. To aid in frame
painting, we’ve included a plastic paint
shield that will protect the speaker baffle.
Painting Tips:
1. If not using spray paint, we recommend
that the paint be thinned to prevent
clogging the speaker grille perforations.
2. When painting, several light coats will
yield the best results.
As the installation of flush-mount speakers
requires cutting into walls where high-
voltage wiring, pipes and duct work may
be present, installation should be
performed by experienced and trained
professionals only.
NOTES:
• Check for Obstructions––Before cutting
holes in any existing wall or ceiling
surface, the cavity behind each speaker’s
installation location MUST be probed
for obstructions. Make sure to probe
both speaker locations in the room to
ensure that symmetrical placement is
feasible.
•Always maintain proper polarity when
wiring speakers. Failure to do so will
result in poor stereo imaging and a
decrease in base response.
CUTTING SPEAKER OPENINGS
IN FINISHED WALLS
1. Use a stud finder to locate the studs
around the intended speaker place-
ment. NOTE: A stud-finding device
MAY NOT detect pipes, wiring, or
other obstructions located behind the
drywall.
2. Use the inside portion of the speaker
cutout template to confirm the speaker
placements.
3. Remove templates and drill or carefully
poke a pilot hole in both locations.
A bent piece of wire or a coat hanger
may be use to probe the stud bay for
obstructions. If you experience resist-
ance of any kind––STOP! If any
© ELAN Home Systems 2003 • All rights reserved. 06/2003
ELAN HOME SYSTEMS
INSTALLATION MANUAL
3
INSTALLATION
PROCEDURES
I
NSTALLATION
OVERVIEW
To Next Page
Loading...
Need help?
General
