Elan S1616A Integration Note

8 of 16
S1616A SOURCE INPUT CONFIGURATION
SINGLE CHASSIS MODE
S1616A Single Chassis Mode Source Settings: To access these settings, Select the S1616A node or
click on Sources under the ELAN S1616A within Audio Zone Controllers on the Media Tab of
Configurator.
Any Source can be assigned to any Input (Mono Source) or Input pair (Stereo Source).
Source Name
The names of the sources. Sources are assigned using the
Source tree.
Type
Right click in the Type column to set Sources as Stereo or
Mono.
Optical
Right click in the Optical column to set the Source input to the
SPDIF optical inputs of the S1616A. Only Input pairs 1/2 and
9/10 can be set to Optical.
Optical inputs are only available for systems that are
comprised of a single S1616A.
IMPORTANT: The S1616 must be power Cycled after
assigning the optical input for the source to function.
In 1 – In 16
Right click in the In columns to assign inputs to Sources.
Stereo Sources use input pairs (In1 / In2, In3 / In4, etc.),
Mono Sources use single inputs.
If a C2 Communications Controller is selected it will always
default to In 16. This setting cannot be changed.
Level
The source volume level (gain). Use these adjustments
(+ / –) on each source to maintain equivalent source volumes
throughout the system.

Elan S1616A Specifications

General

Brand	Elan
Model	S1616A
Category	Amplifier
Language	English