www.elationlighting.com
12 PLATINUM FLX™ User Manual
LAMP SAFETY INSTRUCTIONS
ALWAYS replace lamp every 1,500 Hours.
Use only Genuine Original Philips™ Platinum 20R lamps.
Other brand lamps may cause damage and void the warranty!
NEVER touch the lamp with your bare hands!
Oil from your hands will shorten the life of the lamp.
Always disconnect the fixture’s main power supply before replacing lamp.
Allow fixture to cool for at least 15 minutes before attempting any type of service.
Make sure ALL covers/panels are replaced/secured before operating the fixture
to prevent any risk and/or damage to eye retina from UV Radiation exposure!
LAMP INSTALLATION PROCEDURE
1. Place fixture on a flat surface and remove (3) screws marked “A”, “B”, and “C”
and then remove lamp cover to access the lamp. (See below)
To Next Page
Loading...