Elation PLATINUM FLX - Program Recording Details; Auto Program Setup

www.elationlighting.com
28 PLATINUM FLX™ User Manual
EDIT PROGRAM – Record Controller – Working With Built-In Program [continued]
To start an Auto Program proceed as follows:
1. Slave Setting
T-;B;9J“Function Mode”.
T+H;IIENTER to confirm.
T-;B;9J“Set to Slave”.
T+H;II ENTER to confirm.
T-elect “Slave 1”, “Slave 2” or “Slave 3”.
T+H;IIENTER to confirm.
T+H;IIMODE/ESC in order to return to the main menu.
2. Automatic Program Run
T-;B;9J“Function Mode”.
T+H;IIENTER to confirm.
T-;B;9J“Auto Program”.
T+H;IIENTER to confirm.
T-elect “Master” or “Alone”.
T+H;IIENTER to confirm.
T+H;IIMODE/ESC in order to return to the main menu.
3. Program Selection for Auto Pro Part
T-;B;9J“Edit Program”.
T+H;IIENTER to confirm.
T-;B;9J“Select Programs”.
T+H;IIENTER to confirm.
T-elect “Auto Pro Part 1”, “Auto Pro Part 2” or “Auto Pro Part 3”, and select which
Slave program is to be sent. Selection “Part 1” means, that the Slave unit runs the
same program as the master units.
T+H;II ENTER to confirm.
T+H;IIMODE/ESC in order to return to the main menu.