To Next PageTo Next Page
Need help?Do you have a question about the elco AEROTOP HYBRID and is the answer not in the manual?
Essential safety rules and warnings for installation, use, and maintenance.
Guidance on safe appliance usage by children and proper disposal of electronic waste.
Details on warranty validity, conditions, and causes that void the guarantee.
Lists the components of the hybrid system, including boiler, heat pump, and control devices.
Explains how the AEROTOP HYBRID system integrates boiler and heat pump for optimal performance.
Describes the hybrid system's capability to cool environments using a reversible heat pump.
Illustrates various system configurations with labelled components for heating and hot water production.
Provides detailed measurements and weights for the external unit models (40-50 M EXT).
Details dimensions and weights for larger external unit models (90-110 M-T EXT) and lists available models.
Presents dimensional drawings and weight specifications for the HYBRID MODULE (internal unit).
Illustrates the overall system layout and provides available pressure curves for internal units.
Table detailing system sizes, flow meter thresholds, and nominal flow rates.
Lists minimum and maximum operating frequencies for the heat pump by capacity.
Graphical representation of cooling and heating operation restrictions based on water and air temperatures.
Technical specifications and conformity details for the remote control unit.
Guidance on positioning the outdoor sensor and its resistance characteristics at different temperatures.
Detailed instructions for installing the outdoor unit, including refrigerant type and general recommendations.
Specifies the minimum required distances for external unit installation to ensure proper airflow and access.
Step-by-step guide for opening lateral passages, removing the front panel, and handling transport of the external unit.
Instructions for positioning and preliminary installation of the HYBRID MODULE, including minimum distances.
Procedure for removing the front panel of the HYBRID MODULE to access internal components.
Details on connecting the HYBRID MODULE to the boiler for water, gas, and electrical systems.
Steps for assembling the condensate drain pipe and fitting covers for the HYBRID MODULE.
Checks and procedures for making hydraulic connections, including system water quality and pipe fittings.
Essential checks before making water circuit connections, ensuring system cleanliness and compatibility.
Specific instructions for connecting the external unit and system pipes to the hybrid module.
Comprehensive guide to electrical connections, including warnings, safety checks, and power supply requirements.
Tables detailing electrical data for external units and the hybrid module, including current, voltage, and cable types.
Step-by-step instructions for ground connection and wiring the external unit, with terminal block diagrams.
Guidance on connecting the internal and external units electrically, ensuring secure power and communication cables.
Detailed wiring instructions for the HYBRID MODULE's electrical panel, including terminal block descriptions.
Instructions for setting boiler parameters related to the hybrid module's operation.
A detailed electrical diagram showing connections between boiler, outdoor unit, and system interface.
Guidelines for positioning and installing the system interface (remote control) and connecting it to the hybrid module.
Instructions for initial setup of the system interface, including language, date/time, and feature overview.
Detailed steps for navigating menus and adjusting various system parameters via the interface.
Configuration of thermoregulation parameters for Zone 1, including temperature ranges and curve adjustments.
Settings for summer/winter changeover, temperature thresholds, and delay times for Zone 1.
Adjusting temperature ranges, thermoregulation types, slope, offset, and max/min temperatures for Zone 1.
Detailed settings for cooling thermoregulation in Zone 1, including slope and offset adjustments.
A comprehensive table outlining system parameters, ranges, and default values for configuration.
Instructions for connecting the module to the outdoor unit and heating system without a boiler.
Guidelines for regular maintenance, safety checks, and refrigerant gas pressure inspection.
Annual checks for system condition, hydraulic seals, refrigerant gas, operation, and pressure.
Explanation of how the external unit's anti-freeze protection activates and stops the circulator.
List of internal unit error codes, their descriptions, and troubleshooting steps for restoring normal operation.
Lists external unit and inverter error codes with descriptions and corresponding error numbers.
Explanation of the information found on the internal unit's data plate.
Details on the labels and information present on the external unit's data plate.
Specifications for refrigerant type, load, GWP, and CO2 equivalent for different external unit models.
General