ELCOM NT-2028 - Scanner Transmitter Settings; Set Transmitter Channel; Set Transmitter ID; Set Corresponding Receiver ID

4
Scanner Transmitter Setting
Enter setting
Setting Code Description Note
Set transmitter channel
Set working channel:
e.g.: NT 111=10#,
set working channel 10. Range: 00-15,
end with #.
0#
1#
15#
Set transmitter ID
Set transmitter ID:
e.g.: NT 121=100#,
set transmitter ID 100.
Range: 1-254, end with #.
1#, 2#...
…
100#,
254#
Set corresponding receiver
ID
Set transmitter reporting to a named
receiver:
e.g.: NT 122=200#,
set corresponding receiver ID 200.
Range: 1-254, end with #.
1#, 2#...
…
100#,
254#
Set beeper
Activate or deactivate beeper function to
indicate whether or not the signals are
received during uploading data.
Signals received: 1 beep
Signals not received: 3 consecutive beeps
Note: this function will affect scanning
speed. Scanning speed is 1 code per
second when it is activated and 3 codes
per second when not.
Range: 2#, 3#.
2#
3#
Restore all original
transmitter settings
Restore this module to original settings.
Save & Exit