Elcometer 108 - Checking the Contents of the Box

R
3
maximum value of hydraulic pressure during the test is recorded and is equivalent to the adhesion of the
coating to the substrate.
The Elcometer 108 Hydraulic Adhesion Tester can be used in accordance with the standard methods:
ASTM D4541, SO 16276-1 and NFT30-606.
Users of this Adhesion Tester may also benefit from other Elcometer adhesion testing equipment - see
“Related equipment” on page 18.
1.1 CHECKING THE CONTENTS OF
THE BOX
• Elcometer 108 Hydraulic Adhesion
Test er
•Dolly, x5
• Dolly tool
• Dolly plug, x5
• Pipemaster heating tongs
• Adhesive
• Carrying Case
• Operating Instructions
Note: The Adhesion Tester is fitted with
either a dial pressure gauge or a digital
pressure gauge.
MODEL 108
Digital gauge model
Dial gauge model
Coupling sleeve
Pin