Need help?Do you have a question about the Elcometer 510 and is the answer not in the manual?
General| Brand | Elcometer |
|---|---|
| Model | 510 |
| Category | Test Equipment |
| Language | English |
Initial setup and startup procedures for the Elcometer 510 adhesion tester.
Instructions for installing and charging the AA NiMH rechargeable batteries.
Procedure for choosing the desired language on the Elcometer 510 display.
Configuration options for the Elcometer 510 display, including brightness and timeout.
Customizing the information shown on the top and bottom halves of the Elcometer 510 screen.
Choosing between MPa, psi, Newtons, or N/mm² for pull test results.
Setting the correct dolly size and corresponding pull rate for adhesion tests.
Steps for preparing and attaching dollies to the test surface for 10mm, 14.2mm, and 20mm sizes.
Specific procedures for scoring concrete surfaces when using 50mm dollies.
Analyzing the dolly and substrate for cohesive, adhesive, or glue failure types.
Interpreting failures on concrete substrates, noting concrete removal from the dolly.
Overview of the Elcometer 510's capabilities for managing test readings in batches.
Setting up new batches with criteria like dolly size, pull rate, and cutting device.
Displaying statistical summaries such as mean, lowest, highest readings, and standard deviation.
Viewing individual measurement values, timestamps, and test durations within a batch.
Details on available dolly sizes and their specific applications for adhesion testing.
Information on dolly cutters for scoring coatings and their part numbers.
Details on standard and thin substrate dolly skirts, including dimensions and part numbers.
Accessory for securing the actuator on vertical or elevated surfaces.
To Next Page
