www.elcometer.com
en-19
R
15.2 DOLLY CUTTERS
Standards or test methods will determine if the Inspector should cut /
score around the dolly prior to test to separate the test area from the rest
of the coating; information which should be recorded with the results.
The Elcometer 510 is supplied with a dolly cutter and handle
appropriate for the dolly size included in the kit. Spare / replacement
cutters are available to purchase using the sales part numbers below.
Description Part NumberFor Dolly Sizes (mm)
Dolly Cutter 14.2mm T9990014CT
Dolly Cutter 20mm T9990020CT
Dolly Cutter 50mm T9990050CT
Dolly cutter handles must be ordered separately - a handle is not
supplied with the dolly cutter accessory.
Description Part NumberFor Dolly Cutter
Dolly Cutter Handle T9990014CT T9991420H
Dolly Cutter Handle T9990020CT T9991420H
Dolly Cutter Arbor T9990050CT T9990050H
15.3 DOLLY SKIRTS
Standard skirts are available for 10mm, 14.2mm and 20mm dollies as
well as 50mm dollies. Special skirts are also available for testing on
thin substrates to even out the load, as using a standard skirt on a thin
substrate may cause the substrate to bend or flex during test.
Description Part NumberFor Dolly Sizes (mm)
Standard Skirt 10, 14.2 & 20mm T999101420S
Thin Substrate Skirt T9990014T 14.2mm
Thin Substrate Skirt 20mm T9990020T
Standard Skirt 50mm T9990050S
Part Number Integrated Support Ring Dimensions
I/D
† ‡
O/D
T999101420S 30mm 40.4mm
T9990014T 16.3mm 40.4mm
T9990020T 21mm 40.4mm
T9990050S 52mm 72mm
15 SPARES AND ACCESSORIES (continued)
† ‡
I/D: Inner Diameter O/D: Outer Diameter
To Next Page
Loading...
