6-5
GETTING STARTED
WATER SYSTEM
Your new Buccaneer Caravan is fitted with an on board dual water pump system.
When the system is first used or if air is sucked into the system when emptying your water
container:
1. Insert plug into wall socket and close lid to lock plug in place.
2. Place carbon filter which is fitted to the hose into the water container.
3. Insert plug into wall socket and close lid to Switch on the 12V supply to pump.
4. Open the farthest away hot water tap from the pump.
5. When the water is flowing smoothly close hot tap and open the cold tap to expel the
remaining air.
• Repeat points 4 and 5 for the second farthest away tap from the pump, until the closest tap is
finally purged of air.
Note: Following these instructions will maximise the performance of your pump.
Water system control panel
Filling your water tank:
Ensure all the taps are in the closed position
and master pump switch is in the off position,
and the pump selection switch is in the EXT
position. Then connect your external water
container to the water inlet using the
connection hose supplied. Then place the
master pump switch to the ON position and
the pump will run and start to fill the water
tank from the external water container/supply.
When the tank is full the float switch fitted in
the tank will switch off the pump.
Note: This function is only for filling the
onboard water tank.
Using taps from an external water container/
supply:
Ensure all the taps are in the closed position
and master pump switch is in the off position,
and the pump selection switch is in the
CENTRE position. Then connect your
external water container to the water inlet
using the connection hose supplied. Then
place the master pump switch to the ON
position and the pump will run until the taps
are closed.
Using taps from the onboard water tank:
Ensure all the taps are in the closed position
and master pump switch is in the off position,
and the pump selection switch is in the INT
position. Then connect your external water
container to the water inlet using the
connection hose supplied. Then place the
master pump switch to the ON position and
the pump will run until the taps are closed.
To Next Page
Loading...
