Eldes ESIM251 - Page 31

USER MANUAL ELDES ESIM251 V1.0
31
FOR ADVANCED USERS
All these features can be congured using program “ELDES Conguration Tool“
0; s
The user receives
a conrmation call
when the output is
disabled;
s- call time in seconds
СT08
The rst digit is a command; the last digit refers to
call time in seconds.
E. g. СT08 means that if conrmation call mode
is enabled, whether for period start ot end, the
call will be forwarded to the user when relay is
disabled. The system will call for 8 seconds.
Setting the user
who receives
conrmations
about period
start/end
UC 1,2,3,4,5
Sets which user is
notied about period
start/end.
UC1
E. g. UC2 means that all conrmations will be
delivered to user No2.
Only one user can be selected.
Setting
conrmation
SMS message for
period start
SS
1
Users are notied
about period start by
SMS message
SS1 means that the preset user is notied about
period start of enabling/disabling C1 output
by SMS message. The user is set by using UC
command. See below.
0
Users are not notied
about period start by
SMS message
SS0
SS0 means that nobody is informed about period
start by SMS message.
Setting
conrmation
SMS message for
period end
SE
1
Users are notied
about period end by
SMS message
SE1 means that the user is also notied about relay
disabling by SMS message.
0
Users are not notied
about period end by
SMS message
SE0
SE0 means that nobody is informed about period
end by SMS message.
Example of SMS message conguring C1 output ways of information by preset schedule:
This message congures C1 output parameters using a schedule.
WT20.15 means that relay enablig time is set for 20:15 every day.
ST1 means the user set the relay to turn on on that time.
PT8.5 means that the relay is enabled and is on for 8 hours and 5 minutes, and after that it turns o and turns on again at 20:15 the
following day etc.
UC2 meansthatinformationaboutenabling/disablingissenttouser’sNo2telephone.
CS1 means that the user is notied about relay enabling by a callback; the duration of the call is set by parameter CT13. CT13 means
that the system calls for 3 seconds.
CT06 means that when the relay turns o after 8 hours and 5 minutes the user is notied by a call again, but call duration is 6
seconds.
SE1 means that the user is also notied about relay enabling by SMS message.
To see the preset values for any command send SMS message with the same format that you use when changing parameters; only
Value structure will have no value:
XXXX–userpassword.ValuestructureisCn,whereCniscommandname(2letters).
E. g. XXXX_SMSEXTRA:OCTE:CB,CT,SB
XXXX_SMSEXTRA:OCTE:WT20.15,ST1,PT8.0,UC2,CS1,CT13,CT06,SE1
XXXX_SMSEXTRA:OCTE:Value1,Value2,……,ValueN