How to add liquid
The e-liquid fill hole is located in the side of the top cap of atomizer tube.
Rotate counterclockwise the regulation ring on the top cap to open the
e-liquid fill hole. Then slowly refill e-liquid into the glass tube. Finally close
the e-liquid fill hole by rotating clockwise the regulation ring.
Note: 1. Please first drip a few drops of e-liquid directly into the pure cotton
wick in the atomizer head so as to make it fully soaked before
vaping.
How to adjust airflow
The amount of airflow can be adjusted by rotating the airflow control ring on
the atomizer base so as to get different vaping experiences.
Precautions
1. Only have your MELO 2 atomizer repaired by Eleaf. Do not attempt to
repair the unit by yourself as damage or personal injury may occur.
2. Do not leave the MELO 2 atomizer in high temperatures or damp
conditions, otherwise it may be damaged. The appropriate operation
temperature is from -10℃ to 60℃ while using.
3. Do not attempt to combine the MELO 2 atomizer with parts from other
brands of e-cigarettes. If it is damaged in this way, our company will not
take on responsibility and your warranty will be void.
Warranty
We are not responsible for any damages caused by human error. Legal
warranty is applied.
Email:info@ismoka.com
Web:www.eleafworld.com
2. Please don’t overfill and make sure the liquid level is between
10%-90%;
3. Please make sure the air-inlet holes on the atomizer base are
closed before refilling e-juice.
To Previous Page
Loading...
