114
VFO B Different Band
Set to YES to allow VFO B to be set to a different band from VFO A. This
allows monitoring two bands at the same time when the sub receiver is
turned on.
Note: If the main and sub receivers are sharing the same antenna, setting
VFO B to a different band will result in a warning message if the low-pass
filter required by the transmit VFO's band is too low to allow reception on
the other VFO's band.
VFO Coarse Tuning
Sets the coarse tuning rate, per-mode, that is selected using the
[KHZ] switch. This tuning rate will apply to the VFO as well as to the RIT
control when MENU:RIT Knob Alt Function is set to VFO CRS. When the
user-specified coarse tuning rate is in effect, the VFO digit underline
changes from white to gold.
Tapping VFO digits directly to select a tuning rate overrides the KHZ
coarse tuning rate.
VFO Counts per Turn
Sets VFO knob counts per turn to 100, 200, or 400 counts.
Wattmeter Cal
Per-band wattmeter calibration value. Can be adjusted to calibrate the
K4's internal wattmeter against a known-accurate external instrument.
This should be done on a mid band, e.g. 40/30/20 meters.
XVTR Band # Select
Specifies the target band number (1-12) for the other XVTR Band
menu entries. See INTERNAL & EXTERNAL TRANSVERTERS for full
details on transverter band setup.
XVTR Band <n> I.F.
Specifies the I.F. for the present transverter band (0-53 MHz). 28 MHz is
used with most transverters.
To Next Page
Loading...
