127
ER58, Transmit TEST mode is in effect: Exit TX test mode by
holding [TEST], then retry the operation.
ER59, Cross-mode split not allowed in DATA modes: SPLIT is not
presently allowed with the VFOs in two different data modes. Exit
SPLIT or set VFO B to a different mode.
ER60, End of Band: Transmit attempted outside the frequency range
of the current ham band. This is only allowed when using the XVTR
OUT jack for transmit, or if the K4 has been authorized for MARS use
(contact Elecraft for details).
ER61, Keyer paddle not allowed: In FSK and PSK modes, the keyer
paddle can be used to send text (by converting CW to FSK/PSK) only if
text decode is turned on. To access text decode settings, tap <MAIN
RX>, then <TEXT DECODE>.
ER62, VFO B band locked to VFO A in diversity mode: This message
is displayed if you attempt to change the band of VFO B while in
diversity mode. When diversity is in use, the sub receiver's filters and
other settings must match the main receiver, which means both must
be on the same band.
ER63, Current antenna is based on transverter band: (1) You may
have MENU:XVTR OUT Test set to ON. This forces the XVTR IN and
OUT jacks to be used, regardless of the selected band. (2) When a
transverter band is in use, the antenna jacks for RX and TX are fixed.
With external transverters, the XVTR OUT (TX) jack is used for
transmit, and RX ANT 1 or XVTR IN/RX ANT 2 for receive. Internal
transverters use ANT4 (SO239) for the combined RX/TX path.
ER64, Diversity not applicable to transverter bands: Diversity mode
cannot be selected if VFO A is set to a transverter band. If only VFO B
is on a transverter band, it will be switched to the same HF band as
VFO A when diversity mode is entered.
To Next Page
Loading...
