57
onto the present one. Holding [M1]-[M4] does auto-repeat. The auto-
repeat interval is set using MENU: Message Repeat Interval.
• To cancel message play, tap [REC], [XMIT], [TUNE], or the keyer
paddle.
• During auto-repeat, the message bank icon changes to "MSG RPT"
and flashes as a reminder.
• Prosigns can be entered into CW/data messages using the following
punctuation marks:
( "KN" + "AR" = "BT" % "AS" * "SK" ! "VE"
• The built-in keyboard includes two special characters for use in FSK
and PSK modes: EOL and EOT. EOL inserts a CR/LF sequence, allowing
messages with formatted lines. EOT can be placed at the end of the
message to terminate the usual 4 seconds of nul characters or
"diddles." (EOT actually inserts a '|' character; this can be entered
when using an attached keyboard to send text.) EOL and EOT
characters appearing in messages have no effect in CW mode.
CW Text Decode
The K4 can decode transmitted and received CW signals, displaying
the text in multiple lines below the panadapter. This can be useful for
learning CW, for copying higher code speeds, or even for the benefit
of a non-CW-operator looking over your shoulder.
To enable this feature:
• tap <MAIN RX> or <SUB RX>, then tap <TEXT DECODE>
• select 1 or 3 lines of receive text
• the recommended threshold setting is AUTO, though in some band
conditions there may be an advantage in selecting one of the fixed
thresholds (1-9)
The K4 will decode CW from both receivers simultaneously, using
separate windows, if both are configured for text decode (you can also
decode CW from one receiver while decoding PSK or FSK on from the
other).
To Next Page
Loading...
