81
Recorded audio may be played back while in transmit mode, allowing you
show stations what they sounded like at your end. However, the most
common use of receive recording is to re-listen to a call or exchange you
may have missed the first time.
To begin recording receive audio, hold [AF REC]. A blue circular icon will
appear beneath the VFO A filter passband graphic. Recording may be done
indefinitely.
To play back receive audio, hold [AF PLAY]. This will bring up the AF PLAY
controls, including A and B selections (main and sub RX audio, respectively),
a time code showing playback position within the 90 second loop, and
"+5" / "-5" buttons for quickly locating the desired position. You may also
use the VFO A knob to search through the recording.
An asterisk (*) appears in the time code whenever the playback position is
within 1 second of the start of the last recording session.
DVR Transmit Messages
In speech modes, the message play and record buttons activate the DVR
(digital voice recorder). These controls are used as follows:
• Select the desired message bank (I or II) by holding [BANK]. Each bank
holds 4 DVR messages.
• To start recording, tap [REC], followed by one of [M1]-[M4]. Remaining
buffer time will be displayed as you speak (90 seconds max each). To save
the message, tap [M1]-[M4] again, or tap the <SAVE> button on the LCD.
You can also tap [REC] to cancel, or tap [CLR] to erase.
• Tap [M1]-[M4] to play. To cancel, tap [REC] or [XMIT].
• To auto-repeat, hold (rather than tap) [M1]-[M4]. To set the message
repeat interval, use MENU:Message Repeat Interval.
• DVR transmit messages can be saved using the BACKUP function
(tap <Fn>, then hold <BACKUP>).
To Next Page
Loading...
