97
• Enter one or more K4 remote-control commands. Each command
must be terminated by a semicolon (;). Refer to the K4 Programmer's
Reference for further details.
• Tap the return arrow to exit the macro editor.
• The function you programmed will now be available for use. If you
programmed any of <Fn> <F1-F8>, the labels you assigned will appear
on the switches.
RTTY CONFIGURATION
This section provides step-by-step instructions to configure the K4 for
RTTY operation using either audio (AFSK mode) or direct modulation
(FSK mode).
(To be completed.)
FT8 / JT / ETC. CONFIGURATION
This section provides step-by-step instructions to configure the K4 for FT8,
JT65, and similar audio-based, weak-signal modes. In all cases, the K4's
DATA mode is used.
(To be completed.)
To Next Page
Loading...
